Invacare Lightweight Bedienungsanleitung PDF herunterladen (Seite 38)

SECTION 5—ARMS

Lightweight, Standard and Heavy Duty Wheelchairs 38 Part No. 1114811

Replacing

1. Push down on front of armrest to ensure it is fully seated in front socket.

2. Press in armrest release button located on armrest front tube.

3. Remove hex screw, spacer and locknut securing the existing armrest and insert to the

wheelchair frame.

4. Remove the existing armrest from frame.

5. Inspect rear tube of new armrest to ensure insert is properly installed with mounting

holes aligned.

6. If not properly aligned, rotate the insert using a flat screwdriver to align the mounting

holes.

7. Insert the hex screw through the armrest mounting bracket, spacer and armrest rear

tube with insert.

NOTE: Ensure the spacer sits flush against the armrest.

8. Install nut onto hex head screw. Torque to 20-30 in./lbs.

9. Rotate armrest down and into the arm socket.

10. Ensure armrest is securely locked into arm socket and armrest release button locks

into place before using.

Removing/Installing Armrests

 WARNING

Make sure the armrest release lever is in the locked position before using the

wheelchair.

HEAVY DUTY WHEELCHAIR: ONLY use heavy duty, fixed height armrests on

heavy duty wheelchairs - otherwise injury or damage may occur.

Heavy duty, fixed height armrests are identified by a circular mark on the rear arm

post above or below the armrest release handle.

NOTE: For this procedure, refer to FIGURE 5.2 on page 39.

Rear Arm Post

Armrest Release

Handle

NOTE: Identifying circular

mark located on rear arm post

above or below armrest

release lever.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 63 64

Keine Kommentare

Invacare Lightweight Bedienungsanleitung Seite 38